Shield v1.4 TLE5206

The latest shield v1.4 offers many improvements over it's predecessor.

It uses three high power TLE5206 chips (one for each motor) in contrast to two low power L298P on the old v1.2 Each single chip on the new board v1.4 is capable of deliver more power than entire old shield v1.2.

It is overbuilt to last and will allow you to cut all day long high up on the board without fail or slow down the sled. You can rest assured that this new shield will be up to the most demanding jobs, while performing well between safe operating margins.

Made in USA with name brand components from authorized distributors to ensure safety and performance.

Visit EastBaySource.com to purchase. More info HERE

The new shield v1.4 offers many improvements over it's predecessor.

Every single one chip, out of the three TLE5206 on the latest v1.4 board is capable of driving more power than the whole old 1.2 shield!

• 3 dedicated motor drivers, one chip (TLE5206) for each motor.
• Each chip delivers up to 5A continuous, 15A combined.
• Output full short circuit protected.
• Over temperature protection.
• Under voltage lockout.
• Bolted, bigger/better heat sink.
• 6 Months warranty

This v1.4 shield is in total almost 4 times more powerful than the older version, and uses one dedicated 5A (6A peak) for each motor, with stainless steel bolted and soldered heat-sinks (not sticker mounted as the v1.2) for maximum heat protection.

It is made in USA with name brand components from authorized distributors, to ensure safety and performance.

See more about the old (1.2) vs new shield (v1.4) HERE

You can buy this shield from our website here